Electrostatic Speakers

For those of you who do not know much about the type of speaker, Electrostatic Speakers might sound familiar to you. They are speakers designed to produce sound through the force acting on the suspended membrane and this is within the electrostatic field. They use a thin diaphragm is flat, and usually consists of a plastic sheet coated with a conductive material is graphite sandwiched on two grid complete with two air gap between the diaphragm and the grid.

Electrostatic Speakers

Speaking on Electrostatic Speakers diaphragm design, you need to know that in general the diaphragm is made of polyester film with a thickness between of 2 to 20 pM. Has good mechanical properties, then the grid was driven by the audio signal so that a uniform electrostatic field moves with the audio signal and produce sound in both networks. This causes the diaphragm force is charged, of course, encourage the movement of air on both sides.


And audio signals must be of high-voltage grid, it is intended that the field produced on Electrostatic Speakers have a pretty good strength. There is a capacitor which applies to the Electrostatic Speakers, they have a high impedance device and of course this is inversely proportional to the speaker electrodynamics which has a low impedance device.


Due to Electrostatic Speakers are usually different from the speaker, then there is always a special transformer designed special for this one speaker. Even so they are very good and have a nice function to produce the best; almost always there is a specific and definite result that create exceptional and special.


Until now, Electrostatic Speakers are built with transforms - less is provided solely for commercial needs. The speakers on this one you could probably make the choice for some specific event, although they can sometimes be expensive but the best research you will find the most suitable.